STIHL MS 241 C-M Manual de Instruções descarregar pdf (Página 41)

MS 241 C-M

English

39

If groove depth is less than specified:

N Replace the guide bar.

The drive link tangs will otherwise

scrape along the bottom of the groove –

the cutters and tie straps will not ride on

the bar rails.

Removing the shroud

N Move the Master Control lever to the

stop position (0).

N Push the hand guard forward – the

chain is locked.

N Open the twist locks (1) by turning

them 1/4 turn counterclockwise with

the combination wrench.

N Remove the shroud (2).

Installing the shroud

N Place the shroud in position.

N Close the twist locks by turning

them a 1/4 turn clockwise.

If there is a noticeable loss of engine

power

N Remove the shroud – see "Shroud"

Removing the air filter

N Clean away loose dirt from around

the filter

NOTICE

Do not use tools to remove and install

the air filter – the air filter could be

damaged in the process.

N Turn air filter 1/4 turn

counterclockwise and remove in the

direction of the rear handle

N Always replace a damaged filter

Cleaning the air filter

N Knock out the filter or blow it clear

with compressed air from the inside

outwards

If knocking-out or blowing-out does not

suffice, or in the case of stubborn dirt or

stuck filter fabric, the filter must be

subjected to a thorough cleaning.

Chain

type

Chain pitch Minimum

groove depth

Picco 1/4" P 0.16" (4.0 mm)

Rapid 1/4" 0.16" (4.0 mm)

Picco 3/8" P 0.20" (5.0 mm)

Rapid 3/8"; 0.325" 0.24" (6.0 mm)

Rapid 0.404" 0.28" (7.0 mm)

Shroud

1

1

1

5902BA027 KN

2

Cleaning the Air Filter

1.

2.

2410BA016 KN

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 127 128

Comentários a estes Manuais

Sem comentários